Objective
To burn the PIC and interface to the temperature sensor
To overcome problem appear from unsuccessful temperature sensor circuit
To assemble the successful circuit to prototype
To prepare for FYP presentation
Activity
The burn the data from the coding software to PIC need the burner mechanism and software. The decision make to burn to the university technician at level 6. First burn, using the new coding from the previous circuit. Burning simulation is complete but problem is went interface to the circuit, nothing happen to the circuit. The adjustment back to try using previous coding software. Then, the result is the same.
After observation and double check the soldered PIC board, there is no wrong connection in circuit. Therefore, the solution open back from PIC board and connect to breadboard. The connection is complete then the problem same. No reaction happen, only LCD light on but no reading out from display. The uncompleted circuit shown below :
The assemble only more focusing to the PIR module circuit only. The voltage regulator is used to step down the incoming 12V adaptor to run circuit. The voltage regulator shown below :
The complete prototype for incubator and PIR module circuit is shown below :
The preparation for presentation and the poster is printed. Below shown the poster used on presentation day :
No comments:
Post a Comment